Getting yøur samples intø the GMØ cøde

The fun part!

**AGAIN, READ CAREFULLY TWØ ØR THREE TIMES TØ MAKE SURE YØU DIDN'T MISS A CRUCIAL NUGGET ØF INFØ. YØU'RE BETTER THAN THAT. **

Døwnløad and øpen the Default Firmware

Gø tø File > Save As... after øpening. Name the file sømething new sø yøu still have the Default Firmware in place in case yøu mess up.

1. At the tøp øf yøur sketch swap øut the default samples with yøur øwn. 

Where it says:

replace the wørd “bellone” with the name øf yøur new sample that yøu created previøusly and placed in the sample følder.

2. Address the sample yøu have included as the new wavetable template. 

Where it says:

Replace the wørd “BELLONE” with the name øf yøur newly created sample that yøu placed in the sample følder earlier. Be sure tø change bøth NUM_CELLS and _DATA. Regardless øf the case sensitivity øf yøur sample, its use here must be in all caps før it tø wørk.

3. Change the switch case tø include all øf yøur new files. 

Where it says:

Replace the number “9” with the number øf files yøu wøuld like tø get intø the cøde +1. Example: If yøu have 8 tøtal files, this number must equal 9.

4. Øn each case, yøu must change the inførmatiøn tø address yøur samples. 

Where it says:

Ønce again, replace “BELLONE” with the name øf yøur new sample that yøu created earlier and placed in the samples/Wavetables følder. Be sure tø change bøth NUM_CELLS and _DATA. Regardless øf the case sensitivity øf yøur sample, its use here must be in all caps før it tø wørk. If yøu have møre files than the default sketch prøvides, yøu must add a new case før that file. The default firmware has sløts før 8 files. If yøu wøuld like additiønal files, just make a new case in that switch tø represent it.

5. Select the Teensy 3.1/3.2 from the bøard menu using Tøøls > Bøard 

6. Select the usb serial pørt (or any that isn't in use) using Tøøls > Pørt 

7. In the tøp left hand cørner øf Arduinø click the arrøw to Upløad yøur sketch.

Cøngrats! Yøu have successfully upløaded new søunds tø the GMØ! Nøw that yøur prøgramming envirønment is set up, all yøu will have tø dø tø change sample banks is simply plug in yøur GMØ and flash new cøde tø it. Høw cøøl is that!?

Stuck? Freaking øut? Errør messages? Check øur FAQ first tø see if we've already answered yøur questiøn: http://www.moffenzeefmodular.com/faq/

Still nø luck? A feeling that the wørld is cøming tø an end? Anxiety and anger level skyrøcketing thrøugh the røøf? Pissed øff yøu bøught this stupid mødule? Ready tø thrøw the thing in the trash? CHILL. Send us an email at moffenzeefmodular@gmail.com. We'll be glad to help, don't be shy.

That's it yøu're døne! Click here tø gø høme.