Configure

[ETHERNET]

enable=y #y: test; n: not test

boardip=192.168.120.214 #visionfive IP

vmip=192.168.120.33 #VM/PC IP

baud=1000M #speed: 100M, 1000M, 10M

expectbaudtcp=50 #expect TCP speed(Mbit/s), to judge the test results

[USB]

enable=y #y: test; n: not test

usbcnt=3 #USB interface counts, max: 4

usb1device=sda1 #usb device1 name

usb2device=sdb1 #usb device2 name

usb3device=sdc1 #usb device3 name

usb4device=sdd1 #usb device4 name

blocksize=512k #blocksize to read

blockcnt=100 #block count to read

expectreadspeed=20 #expect USB read speed(Mbit/s), to judge the test results

[SD]

enable=y #y: test; n: not test

sddevice=mmcblk0p3 #sd name

blocksize=512k #blocksize to read

blockcnt=100 #block count to read

expectreadspeed=3 #expect SD read speed(Mbit/s), to judge the test results

[WLAN]

enable=y #y: test; n: not test

vmip=192.168.50.11 #VM/PC IP

baud=1000M #speed: 100M, 1000M, 10M

expectbaudtcp=50 #expect TCP speed(Mbit/s), to judge the test results

ssid=sdstarfive #Wifi name

psk=sd22979600 #WiFi password

[BLUETOOTH]

enable=y #y: test; n: not test

devmac=B4:EE:25:EB:B8:E0 #bluetooth device MAC addr

[HDMI_PWMADC]

enable=y #y: test; n: not test

Run

1. modify the configure file cfg.ini as required

2. copy the folder test_script to board catalogue /

   If you have built TF Card Booting Image, you can see two partitions as follows:

   /dev/sdb1       130M   65M   66M  50% /media/jianlong/4B80-BB12
   /dev/sdb3        29G  162M   27G   1% /media/jianlong/465a8d4f-31fe-40c3-951e-4a565bd3a620
   

   copy the folder to /dev/sdb3

   sudo cp -r test_script/ /media/jianlong/465a8d4f-31fe-40c3-951e-4a565bd3a620/ && sync
   

3. plug the tf card to slot, power on, execute the command to run test script

   cd /test_script && chmod 777 * && sh product_test.sh
   

4. if enable to test USB, make sure plug the U disk first;

5. if enable to test SD, make sure plug the tf card to slot;

6. if enable to test ETH0, make sure ETH0 connect to PC/VM through a network cable, the PC/VM IP and ETH0 IP are on the same network segment, PC/VM open the iperf3 service, such as iperf3 -s;

7. if enable to test WIFI, make sure the different network card of PC/VM connect to router, PC/VM open the iperf3 service, such as iperf3 -s

8. if enable to test BLUETOOTH, make sure the device can be scanned during test

9. if enable to test HDMI/PWMADC, make sure input the result manually during test