Ender 6 Supported?

[mcbaer]

Hi, I was wondering if this is support by the Ender 6?
It has the DMT48270c043_06WT screen on it, which I believe is the same as the Ender 5?

I just wanted to check before I tried flashing it, as I don't want to brick the touchscreen.
Also I'm not really sure what changes I need to make in Marlin for this to work either? Is there a Wiki on this?

I went to your repo for Marlin, but it says to go to the Official Marlin now, but I don't know what changes to make on there, and no one in the Marlin Discord will help.

[Desuuuu]

According to the model number, it should be compatible.

For your configuration, you can have a look at the examples. They're most likely out-of-date but the patch files should give you a general idea of what's needed.

[mcbaer]

According to the model number, it should be compatible.

For your configuration, you can have a look at the examples. They're most likely out-of-date but the patch files should give you a general idea of what's needed.

Thanks. It seems to be working so far. Although some of the buttons are a bit tiny (like the up/down arrows on the Z Offset Screen) so got tap them with my pinky finger LOL..

But the UI looks really nice; super clean.. I like that.. though the boot up sound kinda loud so it pops the speaker a bit.. but I'll adjust that later..