05. IR Learning Remotes

Abstract

IR Learning Remotes are able to use commands from a variety of other remotes (called Donor Remote), and are recognizable by a section of buttons located in a Study Zone, similar to the one in the pictures bellow:

Basic instructions

These instructions should work with most types of factory bundled IR Learning Remotes

1. On the IR Learning Remote, press the (blue) Power Button for 5 seconds, until the LED indicator remains on.
2. Press a (blue) Study Button. The LED indicator should start flashing, indicating the remote is ready to learn.
3. Place the IR Learning Remote and the Donor Remote 3-5 millimeters apart with the IR Sensors facing each other.
4. On the Donor Remote, press the button that needs to be programmed into the Study Button.
5. The LED indicator blinks 3 times on the IR Learning Remote then stays on. The Study Button has been programmed.
6. Repeat steps 2 to 4 till all Study Buttons have been programmed.
7. Once finished programming the IR Learning Remote, press any button outside the Study Zone. The LED indicator will turn off.

NOTE: If the study fails, the LED blinks 5 times. Simply repeat the steps.

Select models only

• Press the upper-leftmost key and the bottom right corner key at the same time for 7 seconds until the LED indicator blinks 3 times to reset the IR Learning Remote.

Learning Remotes

A collection of instructions on how to program different models with IR learning capabilities:

G10	G30	G40S
MX3 Air Mouse	Rii i25	F10 Air Mouse