diff --git a/README.md b/README.md
index fddc14f..5b43fb1 100644
--- a/README.md
+++ b/README.md
@@ -13,20 +13,17 @@ Configure it as follows:
             "accessory": "gz-yeti",
             "service": "Switch",
             "name": "Yeti",
-            "url": "http://[your Yeti's IP Address]",
-            "model": "Your Yeti Model",
-            "devname": "Your Yeti device name",
-            "serialnumber": "Your Yeti Serial number",
-            "firmwareversion": "Your firmware revision",
-            "showHumidity": "no"
+            "model": "Yeti 3000",
+            "firmwareversion": "1.2.3",
+            "macaddress": "3C71BF7D7810",
+            "url": "[your Yeti's IP Address]"
         }
         
 ### Note:
  * Only the url is critical, the rest of the fields are for information or future development.  These values can be found in the Yeti app.
  * name is the name of the device as it appears in Homekit
  * model appears under the detailed info page in the settings page for the device in Home.app.
- * serialnumber appears under the detailed info page in the settings page for the device in Home.app.
- * showHumidity will use the humidity sensor in Homekit to display the charge state of the battery - it's otherwise buried.
+ * macaddress appears under the detailed info page in the settings page for the device in Home.app.
  * firmware version is currently not used, it's there in case any future firmware updates cause breakage.
  * Siri responds to "Turn AC Power on/off", "Turn 12 volt power on/off", "Turn USB power on/off"