Customize Happy Face on Display

[LayerCakeMakes]

This is a minor feature request for sure, but it would be nice to be able to customize when the happy/unhappy face is shown.
I, like many others, use the LYWSD03MMC to monitor the dryness of my 3D printer filament, so the lower the better which currently always leads to a unhappy face. I would love to be able to change this.

[LayerCakeMakes]

Ahh I think I put this in the wrong repository. Moving this to devbis/z03mmc.

[pvvx]

ZHA does not have tools for configuring Zigbee devices.

The answer to your question from devbis is here:
devbis/z03mmc#61 (comment)

[pvvx]

Now I add:

AttrID 0x0002 - show_smiley - 0 on, 1 - off

[pvvx]

Ver 0.1.1.4: According to the "ZigBee Cluster Library Specification" the "Thermostat Temperature Conversion" values have been corrected. Added On/Off smiley.
ClusterID: 0x0204 (Thermostat User Interface Configuration), Attr: 0x0000 (TemperatureDisplayMode), ENUM8 = 0 in C, = 1 in F,

Attr: 0x0002 (ScheduleProgrammingVisibility), ENUM8 = 0 show smiley On, = 1 show smiley Off

[LayerCakeMakes]

That's a nice compromise. Dryer mode (happy below 30% at 20C) might be a bit to special, just disabling the smiley should be good enough.

[pvvx]

But this cannot be done in ZHA.

[LayerCakeMakes]

OK