Parts cooling fan set up

[bdelia]

Hello,
I am having troubles figuring out how to set up my parts cooling fan. I have my Extruder Cooling Fan set up on FAN1_PIN.
Now I am trying to set up the parts cooling fan, but I am not sure what to set below. I have the fan plugged into P1.04 and I have the parts cooling fan plugged into P2.04. Any help is appreciated. I have tried setting each COOLER_AUTO_FAN_PIN and COOLER_FAN_PIN equal to FAN_PIN but have not had luck with the parts cooling fan working yet. I know the fan is good, already tested that.

Below is the fan section of my Config_adv.config:
`
#define E0_AUTO_FAN_PIN FAN1_PIN
#define E1_AUTO_FAN_PIN -1
#define E2_AUTO_FAN_PIN -1
#define E3_AUTO_FAN_PIN -1
#define E4_AUTO_FAN_PIN -1
#define E5_AUTO_FAN_PIN -1
#define E6_AUTO_FAN_PIN -1
#define E7_AUTO_FAN_PIN -1
#define CHAMBER_AUTO_FAN_PIN -1
#define COOLER_AUTO_FAN_PIN -1
#define COOLER_FAN_PIN -1

#define EXTRUDER_AUTO_FAN_TEMPERATURE 50
#define EXTRUDER_AUTO_FAN_SPEED 255 // 255 == full speed
#define CHAMBER_AUTO_FAN_TEMPERATURE 30
#define CHAMBER_AUTO_FAN_SPEED 255
#define COOLER_AUTO_FAN_TEMPERATURE 18
#define COOLER_AUTO_FAN_SPEED 255

/**

• Part-Cooling Fan Multiplexer
• This feature allows you to digitally multiplex the fan output.
• The multiplexer is automatically switched at tool-change.
• Set FANMUX[012]_PINs below for up to 2, 4, or 8 multiplexed fans.
  */
  #define FANMUX0_PIN FAN_PIN
  #define FANMUX1_PIN -1
  #define FANMUX2_PIN -1

Here is my pins_MKS_SGEN_L_V2 relevant section:
//
// Heaters / Fans
//
#define HEATER_BED_PIN P2_05
#define HEATER_0_PIN P2_07
#if HAS_MULTI_HOTEND
#ifndef HEATER_1_PIN
#define HEATER_1_PIN P2_06
#endif
#else
#ifndef FAN2_PIN
#define FAN2_PIN P2_06 // HE1 for FAN3
#endif
#endif
#ifndef FAN_PIN
#define FAN_PIN P2_04 // FAN1
#endif
#ifndef FAN1_PIN
#define FAN1_PIN P1_04 // FAN2
#endif`

[furkankarayel]

Have you solved your problem yet? I'm stuck with this issue