ADSR base pcb unconnected trace

[justjoheinz]

Unfortunately I just ordered some PCBs after I noticed in the Kicad file that there is one unconnected trace near D6 which you can find by invoking the Design Rule Checks.

[mannes]

@justjoheinz you probably need not worry, the traces should still connect through the power header solder holes. You can check that out in kicad too.
Have you received/tested the PCBs already?

[justjoheinz]

I got them today and the ordered parts are on the way. Will do some measuring once I am home.

[mannes]

I've ordered a couple PCBs too, will post back when i find out this is a problem or not :)

[justjoheinz]

I build mine now but have not tested it yet as the panel pcb holes for the pots are to narrow and I will need to widen them.

Another issue was with the power connector. It was a very tight fit but worked.

[supermorel]

So? Working or not?

[mannes]

So? Working or not?

Didn't get to building it myself yet, however i have seen several successful builds on the facebook eurorack diy group. Had no trouble test-fitting (Song Huei) pots and (shroud less) power connector though

[kraakenstuff]

What's that unconnected trace near the D6?