pcba-test

This is automated testing of the PCBAs for the Cacophony Project

Setup

This is intended to be tested on a Raspberry Pi 3B

Install thermal-recorder https://github.com/TheCacophonyProject/thermal-recorder/releases
Install the latest attiny-controller https://github.com/TheCacophonyProject/attiny-controller/releases
Enable thermal-recorder service sudo systemctl enable thermal-recorder
Enable leptond service sudo sudo systemctl enable leptond
Enable attiny-controller service sudo sudo systemctl enable attiny-controller
Replace /boot/config.txt on Raspberry Pi with config.txt
Make enpty config file touch /etc/cacophony/config.toml
Setup wifi on Raspberry Pi so you can connect to it on over the same network. https://www.raspberrypi.org/documentation/configuration/wireless/wireless-cli.md
Download and install the latest pcba-test package.
Have a ATtiny85 programmed (at 8MHz) with the latest code from https://github.com/TheCacophonyProject/attiny
(optional) change hostname of the Raspberry Pi if you are setting up more than one test device

Power off Raspberry Pi
Put Hat on Raspberry Pi
Attach:
- RTC battery
- Thermal camera
- Speaker
- ATtiny
- Reset/LED button
- Attach USB cable from Raspberry Pi to HAT
- Put USB drive in HAT
Power up through power plug on HAT
Open a web browser on a device that is on the same wifi as the Raspberry Pi and go to <RPi-devicename>.local
Press Run Tests and wait for it to finish
Press Play Sound and check that it played a sound
Press View Camera and check the output from the camera (this can take a minute or two sometimes to start from boot)