Odd "View Mesh" results after V2.0.2h Firmware

[K2Kevin]

I was running the latest Jyers firmware for a little while now, few days ago installed the V2.0.2h Update link here by @tititopher68-dev. I run a Mesh leveling process and save new mesh randomly, especially before doing a "big/long" print and view the results. I noticed since installing this V2.0.2h firmware, my mesh results are not what im used to seeing (Images attached). Has the leveling procedures changed? I go back to check a corner using the manual leveling menu item, and suddenly everything is low. I complete a manual leveling, (My Z-Offset is still what I have saved), then proceed to mesh leveling and get this unusually high results. I check manual leveling and again very low at all corners. Im like WTF is going on, not what I expected.

On the bright side, regardless of these ugly results, I get perfect smooth like butter prints!

Previous Jyers v2.0.1 Firmware Mesh Results:

V2.0.2h Firmware Mesh Results: