After UBL printer in weird state

[patofoto]

After I use the Bed Visualizer plugin to build a mesh of my bed, my printer display is stuck as if I was printing something:

I try to cancel the "print" but the confirm button has no effect.

Wondering if it is the G-Code I am using for the mesh build:

G28       ; home all axes
M155 S30  ; reduce temperature reporting rate to reduce output pollution
M190 S60  ; (optional) wait for the bed to get up to temperature
G29 P1    ; automatically populate mesh with all reachable points
G29 P3    ; infer the rest of the mesh values
G29 P3    ; infer the rest of the mesh values again
@BEDLEVELVISUALIZER	; tell the plugin to watch for reported mesh
M420 S1 V ; enabled leveling and report the new mesh
M500      ; save the new mesh to EEPROM
M155 S3   ; reset temperature reporting
M300 S1000 P500 ; chirp to indicate bed mesh leveling is done and saved

Any help would be appreciated

[deepusudhakar]

Seeing the same issue on my end with the same GCODE (grabbed from the plugin’s FAQ). Did you ever find a solution to this problem?